![]() ![]() Failsafe value will be saved automatically after CRSF-PWM board is powered on and receive CRSF signal.Bridge PWM1 and PWM2 signal pad, then power on CRSF-PWM board and receiver.Make sure ESC signal is disconnected from CRSF-PWM board before starting failsafe settings.you can change the failsafe value of CH3 and other channels by following settings. CH3 is arranged for the throttle, Failsafe value = 988 by default.Usually put the Throttle joystick to the lowest point, put AIL(Roll), ELE(Pitch), RUD(Yaw) middle before powering on receiver.CH3 is specially arranged for the throttle, Failsafe value = 988 by default.Failsafe value = The PWM value of each channel(except CH3) when CRSF signal is received by CRSF-PWM board for the first time.Failsafe value is set automatically after CRSF-PWM board is powered on and receive CRSF signal.4v5 pad voltage = 5V pad voltage -0.3V, make sure the voltage on 5V pad is not higher than receiver and GPS rated voltage.Vbat(CRSF-PWM-B) ): (6~30V) Battery voltage sensing and power supply of onboard BEC.Vbat(CRSF-PWM-6 and -C ): (0~36V) Battery voltage sensing.Tx2/Rx2(UART2) for GPS/firmware update/setting parameters.Tx1/Rx1(UART1) for CRSF protocol Receiver.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |